Electronic and DDC Systems

  • Items 73-96 of 231. Page 4 of 10.
C7100B1013 Honeywell Averaging Temperature Sensor. Range
Averaging Temperature Sensor. Range 40-150F. 22800 Ohms At 77F. Sensitivity: 675 Ohms Per Degree. Use With W7080. Negative Temperature Coefficient

Honeywell

C7100B1013

085267039376

2 In Stock
C7100D1001 Honeywell 13 inch fast response duct
13 inch fast response duct averaging sensor with mounting flange. PT1000 Sensor 1097 Ohms at 77F. 2.1 Ohms per degree linear PTC. Use with new style T775

Honeywell

C7100D1001

085267039406

15 In Stock
C7150B1004 Honeywell Temperature Sensor. Range -40 To
Temperature Sensor. Range -40 To +110F. 3000 Ohms At 77F. Sensitivity: 70 Ohms Per Degree. Use With W973 Or M7415A. Negative Temperature Coefficient OBSOLETE

Honeywell

C7150B1004

085267039437

1 In Stock
C7233A1008 Honeywell CO2wallSensrW/Display
CO2wallSensrW/Display

Honeywell

C7233A1008

1 In Stock
C7250A1001 Honeywell Buildings 20K MA Sensor for W7220
20K MA Sensor for W7220

Honeywell

C7250A1001

085267647953

105 In Stock
C7400A2001 Honeywell Enthalpy sensor. 4-20 mA
Enthalpy sensor. 4-20 mA * Enthalpy sensor for Honeywell Economizers. Supply 12 to 40 VDC. Out put 4-20 mA. Replaces C7400A1004 & C7400A1012 & lennox 54G44 C7400A2017

Honeywell

C7400A2001

085267555890

15 In Stock
C7400S1000 Honeywell Enthalpy sensor for W7220 Jade
Enthalpy sensor for W7220 Jade Economizers. Silk bus communication.

Honeywell

C7400S1000

085267920940

53 In Stock
C7660A1000 Honeywell Dry bulb sensor for W7459, W7212,
Dry bulb sensor for W7459, W7212, W7213, W7214 & W7215 economizers. DIP switch selectable Change over 48, 53, 55, 58, 63, 68, 73, 78 degrees. Sends 4mA when not ok for economizer, 20 mA when ok.

Honeywell

C7660A1000

085267599627

14 In Stock
C7772A1004 Honeywell Flush mounted wall sensor for Excel
Flush mounted wall sensor for Excel 5000 systems. 20K NTC non linear Negative TCR. 20000 ohms at 77F.

Honeywell

C7772A1004

085267192569

1 In Stock
CM-12 Macurco Aerionics Carbon monoxide detector with
Carbon monoxide detector with display and buzzer. 120 Volts. Fan Relay 25, 35, 50 or 100 PPM. Alarm relay off, 50, 100, 150 or 200 PPM. 4-20 mA output 0-200 PPM. Adjustable Fan delay and minimum run time. Display and buzzer can be enabled

Macurco

CM-12

4 In Stock
CM-6 Macurco CO Gas Detector. SPDT, 4-20 displa
CO Gas Detector. SPDT, 4-20 displa Carbon Monoxide Detector with display and buzzer. 12-24VAC, 12-32VDC. Fan Relay 25, 35, 50 or 100 PPM. Alarm relay off, 50, 100, 150 or 200 PPM. 4-20 mA out put 0-200 PPM. Adjustable Fan delay and minimum run time. Display and buzzer can be enabled. Replaces CM21A & CM-2B

Macurco

CM-6

7 In Stock
CMP-PMS Pelican Cmp-pms Hotel Property Management
Hotel Property Management Interface

Pelican Wireless Systems

CMP-PMS

Not in stock
CSP-5001 Kmc Controls Pressure independent VAV control
Pressure independent VAV control and actuator. 24 volts, 4VA. 50 in/lb torque, 90 degrees rotation at18 degrees per minute. Reset voltage 0-10 VDC. 0-3300 FPS. Direct couple to 1/2 inch shaft. Used with CTE-5100 series thermostats. KREUTER

KMC Controls

CSP-5001

2 In Stock
CTE-1001-10 Kreuter Electronic thermostat for KMC
Electronic thermostat for KMC CEP/CSP-4000 series controller actuators. DA cooling. Horizontal mount

KMC Controls

CTE-1001-10

Not in stock
CTE-1004-10 Kreuter Thermostat for CEP/CSP RA/DA
Thermostat for CEP/CSP RA/DA * Electronic thermostat for KMC CEP/CSP-4000 series controller actuators. RA heating, DA cooling. Horizontal mount obsolete

KMC Controls

CTE-1004-10

1 In Stock
CTE-5101-10 Kreuter Single setpoint VAV thermostat
Single setpoint VAV thermostat * Single setpoint, direct acting VAV room thermostat. 16 volts supplied from CSP VAV control. Output 0-10VDC. Range 55 to 85F. Proportional abnd 2 or 4F.

KMC Controls

CTE-5101-10

5 In Stock
CTE-5103-10 Kreuter Kmc Dual setpoint, direct and reverse
Dual setpoint, direct and reverse acting VAV room thermostat. 16 volts supplied from CSP VAV control. Output 0-10VDC. Range 55 to 85F. Proportional abnd 2 or 4F.

KMC Controls

CTE-5103-10

2 In Stock
CTE-5104-10 Kreuter Room thermostat for KMC CSP-500X &
Room thermostat for KMC CSP-500X & REE-X000 systems. 16 VDC. Output 0-10VDC.Dual setpoint, Direct & reverse acting.

KMC Controls

CTE-5104-10

12 In Stock
CTE-5202 Kmc 24 Volts & 0-12VDC Output
24 Volts & 0-12VDC Output Almond Thermostat. * Can Replace TP8101 Thermostat; Verify Application.

KMC Controls

CTE-5202

17 In Stock
D350AA-1C Johnson Display Module For System 350
Display Module For System 350 * Display Module Used With System 350 Controls. Used To Display Set point And Sensed Temp. Surface Or Din Rail Mount. Powered By 5 Vdc Which Is Supplied By The A350 Temperature Control.

Johnson Controls

D350AA-1C

1 In Stock
D352CA-1C Johnson Display Module 0-9.99WC
Display Module 0-9.99WC * Display Module Used W/System 350 Pressure Controls. Used To Indicate Sensed Press. And Press. Set point. Range Is 0-9.99 In.Wc. Surface Or Din Rail Mount. 14 Vdc. Supplied By P352 & P352P Modules.

Johnson Controls

D352CA-1C

1 In Stock
D352CA-2C Johnson Display Module -.5 To +.999 Wc
Display Module -.5 To +.999 Wc * Display Module Used W/Sys. 350 Pressure Controls. Used To Indicate Sensed Press.& Press. Set point. Range Is -0.500 To .999 With surface Or Din Rail Mount. 14 Vdc Is Supplied By The P352 & P352P Module.

Johnson Controls

D352CA-2C

9 In Stock
DRC Aci DIN Rail Adapter Clip
DIN Rail Adapter Clip

Automation Components Inc

DRC

20 In Stock
EP-8000-2 Johnson Controls E-P Transducer Relay Type. Input
E-P Transducer Relay Type. Input 0-10 Vdc. Output .5-19 PSI. Adjustable Zero And Span.

Johnson Controls

EP-8000-2

13 In Stock
  • Items 73-96 of 231. Page 4 of 10.